![]() ![]() You’ll find lots of conflicting opinions on which method is better, but the correct answer really depends on a number of factors: the type and age of the brick, the depth and diameter of the holes, the type of anchor you use, and the weight you’re placing on the fasteners.īrick usually holds better and supports more weight than mortar. Rental bits run around $4 each (as opposed to upwards of $25 each to purchase), and you’ll need two for larger holes: a smaller bit for drilling a pilot hole and one that’s the recommended size to finish the job.Īs you position the object on the wall and lay out the required holes, your next decision will be whether to drill into the brick itself or the mortar. If it’s an option, consider renting carbide masonry bits instead of buying while you’re at it. Look for an option that has a stop guide attachment, multiple speeds, and an auxiliary side handle. These drills cost about $25 for four hours, but they get the job done in a fraction of the time and with far less physical effort. Larger holes are much easier to make with a hammer drill, which is a power drill that bores holes into brick and concrete using rapid hammer-like blows. ![]() Instead, head to a home improvement store’s tool rental center for something heavy-duty. However, if you’re mounting heavier objects that require multiple larger and deeper holes, don’t even think about using your own drill-it will take too long and you’ll burn up the motor. ![]() Just buy a carbide-tipped masonry bit from your local hardware or home center and follow the steps below. Typically, all it takes is an ordinary drill to bore a few small 1″-deep holes (each a ¼-inch in diameter or less). ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |